After buying launch x 431 pro , We need begin use launch x431 pro for diagnostic cars.
First, Connect DBScar
Locate vehicle’s DLC socket. The DLC (Data Link Connector or Diagnostic
Link Connector) is the standardized 16-cavity connector where diagnostic
code readers interface with the vehicle’s on-board computer. The DLC is
usually located 12 inches from the center of the instrument panel
(dash), under or around the driver’s side for most vehicles. If Data
Link Connector is not located under dashboard, a label should be there
telling location. For some Asian and European vehicles, the DLC is
located behind the ashtray and the ashtray must be removed to access the
connector. If the DLC cannot be found, refer to the vehicle’s service
manual for the location.
Plug the DBScar diagnostic connector into the vehicle’s DLC socket (It
is suggested to use the OBD 2 extension cable to connect DBScar
connector and DLC socket.). For non-16PIN DLC socket, please select the
corresponding non-16 pin connector adaptor, then plug the non-16pin end
of the adaptor into the DLC socket, and then connect the standard 16pin
end DBScar connector.
The second, setting bluetooth for launch x431 pro diagnostic tool
Enter X-431 PRO
Bluetooth setting screen (“Settings” –> “Wi-Fi” –> “Bluetooth”),
slide the Bluetooth switch to ON and X-431 PRO will start searching
available Bluetooth device, click the desired connector to piar and
match.
The third, Start diagnosing
Take Demo as an example to demonstrate how to diagnose a vehicle. Start
the software to enter vehicle selection screen. Click “Demo” to enter
demo menu screen. Click “DEMO” to enter system selection screen. Click
“Engine”, the system starts initializing and then jump to the function
menu.
没有评论:
发表评论