2018年4月16日星期一

To update Autel MS908P firmware

To update Autel MaxiSys MS908 Pro firmware

    1.Power up the MaxiSys pro tablet, and ensure that it is connected to a power source and with steady internet connection
    2.Tap the Update application button from the MaxiSys Job Menu; or tap the update notification message when received one. The Update application screen displays.
    3.Check all available updates:

If you decide to update all the items, tap the Update All button

If you want to update some individual items, tap the Update button on the right column of the specific item.



    4.Tap the Pause button to suspend the updating process. When you tape Continue to renew the update, the updating process will resume from the break point.



    5.When the updating process is completed, the firmware will be installed automatically. The new version will replace the original version if thee is one.



VCI Manager Operations

This application allows you to pair up the MaxiSys Display Tablet with the Bluetooth VCI device-the Wireless Diagnostic Interface, and to check the communication status.



VCI Manager screen



    Connection Mode- there are two connection modes available for selection. The connection state is displayed alongside.

BT Paring-when paired to a wireless device, the connection state displays as Paired; otherwise it displays as Unpaired.

Update(for VCI software only)-Update VCI software via internet through the MaxiSys tablet networking using USB connection.



    BT Setting

The BT Setting screen displays the type and a partial serial number for all of the device available for pairing. Tap a required device to start paring. The BT status icon displayed to the left of the device name indicates the received signal strength.



BT Paring


The VCI module needs to be either connected to a vehicle or to an available power source, so that it is powered up during the synchronization procedure.

Make sure the Autel Maxisys Display Tablet has a charged battery or is connected to an AC/DC power supply.



To pair the VCI module with the MaxiSys system

    Power on the MaxiSys display Tablet
    Connect the 26-pin end of the data cable to the J2534 ECU Programming Device’s vehicle data connector
    Connect the 16-pin end of the data cable to the vehicle data link connector (DLC)
    Tap the VCI Manager application on the MaxiSys Job Menu of the tablet
    Select BT from the connection mode list
    Tap the Scan button at the top right corner. Now the device starts searching for available pairing units.
    Depending on the VCI type you use, the device name may display as Maxi suffixed with a serial number. Select the required device for pairing.
    When pairing is successfully done, the connection status displayed to the right of the device name is shown as Paired.
    Wait a few seconds, and the VCI button on the system Navigation bar at the bottom of the screen shall display a green tick icon, indicating the display tablet is connected to the VCI device.
    Tap the paired device again to unpair it.
    Tap the Back button on the top left to return to the MaxiSys Job Menu.



NOTE:


A VCI module can be paired to only one Display Tablet each time, and once it’s been paired, the device will not be discoverable for any other unit.



Before update the VCI software, please make sure the MaxiSys tablet network connection is stable.



Update VCI Software



To update the VCI device software

    1.Power on the MaxiSys display tablet
    2.Connect the VCI device to MaxiSys tablet via USB
    3.Tap the VCI Manager application on the MaxiSys Job Menu of the display tablet
    4. Select Update from the connection mode list
    5.The current version number and the latest version number of the VCI software will be displayed after a few seconds, click Update Now to update the VCI software if available

没有评论:

发表评论